Htc LZC5227 / 965879701 Bedienungsanleitung

EnglishOperator Manual LZC5225 / 965879601 LZC5227 / 965879701 LZC6130 / 965879801 LZ30 / 968999776Please read the operator’s manual carefully and m

SAFETY10 - Husqvarna8011-520Never take passengersWatch for trafc when operating near or crossing • roadways.Use extra care when loading or unloading

SAFETYHusqvarna - 11Personal Safety Equipment8011-670aPersonal protective equipment6003-004Mow up and down, not side to sideMake sure that you have r

SAFETY12 - Husqvarna8011-509Be extra cautious when driving on slopes8011-517Never allow children to operate the machine8011-518Keep children away from

SAFETYHusqvarna - 13Safe Handling of GasolineTo avoid personal injury or property damage, use extreme care in handling gasoline. Gasoline is extremely

SAFETY14 - Husqvarna8011-515Never drive the machine in an enclosed spaceGeneral MaintenanceNever operate machine in a closed area.• Keep all nuts and

SAFETYHusqvarna - 15Sparking can occur when working with the battery • and the heavy cables of the starter circuit. This can cause battery explosion,

SAFETY16 - HusqvarnaIMPORTANT INFORMATIONThe parking brake is not sufcient to lock the machine in place during transport. Ensure that the machine is

SAFETYHusqvarna - 17WARNING!This mower is equipped with an internal combustion engine and should not be used on or near any unimproved forested, bush

CONTROLS18 - HusqvarnaThis operator’s manual describes the Husqvarna Zero Turn Rider. The rider is tted with either a Kohler or Kawasaki four-stroke

CONTROLSHusqvarna - 198011-788Steering controlsMotion Control LeversThe machine’s speed and direction are continuously variable using the two steering

©2008 HTC. All rights reserved.Beatrice, NE. Printed in U.S.A.In order to implement improvements, specications and designs can be altered without pri

CONTROLS20 - HusqvarnaHour meterThe hour meter displays the total operating time.It will ash CHG OIL (Change Oil) at 50 hour intervals. The ash dura

CONTROLSHusqvarna - 21FusesThe fuses are located in a holder to the left of the hydraulic tank. They are at pin fuses of the same type used in automo

CONTROLS22 - HusqvarnaIMPORTANT INFORMATIONExperience indicates that alcohol blended fuels (called gasohol, ethanol or methanol) can attract moisture

CONTROLSHusqvarna - 23Seat LockUnder the rear section of the seat is a lock device to lock the seat into a folded position. The seat has a linked xtu

CONTROLS24 - HusqvarnaMower Deck Lifting LeverThe lifting lever is used to place the mower deck in the transport position or one of the 17 different c

CONTROLSHusqvarna - 25IMPORTANT INFORMATIONTo obtain an even cutting height it is important that the air pressure in all four tires is the same 15 psi

OPERATION26 - HusqvarnaRead the “Safety Instructions” section and the following pages if you are unfamiliar with the machine.TrainingZero turn mowers

OPERATIONHusqvarna - 278011-527Start conditions8011-753Raise the mower deckStarting the EngineSit on the seat.1. Raise the mower deck by pulling the l

OPERATION28 - Husqvarna8011-510Depress the control for disengaging the mower deck8011-526Steering controls in the outward, locked neutral position8011

OPERATIONHusqvarna - 298011-742Turn to the start position8011-508Set the choke controlOpen the valve for the selected fuel tank.8. 8011-506Open the fu

CONTENTSINTRODUCTION ...5Driving and Transport on Public Roads ...5Towing ...

OPERATION30 - HusqvarnaWhen the engine starts, immediately release 10. the ignition key back to the run position.IMPORTANT INFORMATIONDo not run the s

OPERATIONHusqvarna - 31Weak BatteryIf “jumper cables” are used for emergency starting, follow this procedure:Jumper CablesConnect each end of the RED

OPERATION32 - HusqvarnaIMPORTANT INFORMATIONThe mower deck’s gauge wheels should be evenly adjusted.8011-561Select the cutting heightRunningRelease th

OPERATIONHusqvarna - 33Operating on HillsRead the Safety Instructions “Driving on Slopes” in the “Safety Instructions”.The slowest speed possible shou

OPERATION34 - Husqvarna8011-603aMowing patternMowing TipsObserve and ag rocks and other xed objects to • avoid collisions.Begin with a high cutting

OPERATIONHusqvarna - 358011-507Vent screws on the hydraulic pumpMoving by HandWhen pushing or pulling the mower with the engine turned off,the vent sc

MAINTENANCE36 - Husqvarna1) First change after 5-8 hours. When operating with a heavy load or at high ambient temperatures, replace every 50 hours. 2

MAINTENANCEHusqvarna - 37Check/adjust throttle cable●Check the condition of belts, belt pulleys● ●Change the engine oil 1)● ●Replace the engine oil l

MAINTENANCE38 - Husqvarna128011-4661. Terminal guard2. Battery hold downsBattery installationBatteryYour mower is equipped with a maintenance free bat

MAINTENANCEHusqvarna - 39Ignition SystemThe engine is equipped with an electronic ignition system. Only the spark plug requires maintenance.For recomm

English-4WARNING!Failure to follow cautious operating practices can result in serious injury to the operator or other persons. The owner must understa

MAINTENANCE40 - HusqvarnaEngine Cooling Air IntakeCheck that the engine’s cooling air intake is free from leaves, grass, and dirt.If the cooling air i

MAINTENANCEHusqvarna - 41Air FilterIf the engine seems weak or runs unevenly, the air lter may be clogged. If running with a dirty air lter, the spa

MAINTENANCE42 - HusqvarnaIMPORTANT INFORMATIONThe end cover must be installed with the rubber valve pointing downwards or the rubber valve will not fu

MAINTENANCEHusqvarna - 43Fuel FilterReplace the line-mounted fuel lter every 100 hours (once per season) or more often if it becomes clogged.Move the

MAINTENANCE44 - HusqvarnaChecking the V-beltsCheck every 100 hours of operation. Check for severe cracking and large nicks.NOTE: The belt will show so

MAINTENANCEHusqvarna - 45Pump beltCheck belt every 100 hours for excessive wear.To replace belt. Relieve tension on the deck belt and remove deck belt

MAINTENANCE46 - HusqvarnaCutter BladesTo attain the best mowing effect, it is important that the blades are well sharpened and not damaged.Bent or cra

MAINTENANCEHusqvarna - 47Adjusting the Mower Deck8011-601-11. Front eyebolt2. Front locknut3. Rear locknut4. Rear eyeboltLeveling the mower deckLeveli

MAINTENANCE48 - HusqvarnaCleaningRegular cleaning and washing, especially under the mower deck, will increase the machine’s life-span. Make it a habit

LUBRICATIONHusqvarna - 49Lubrication ScheduleGeneralRemove the ignition key to prevent unintentional movements during lubrication.When lubricating wit

Husqvarna - 5INTRODUCTIONCongratulationsThank you for purchasing a Husqvarna ride-on mower. This machine is built for superior efciency to rapidly mo

LUBRICATION50 - HusqvarnaLubricating the CablesIf possible, grease both ends of the cables and move the controls to end stop positions when lubricatin

LUBRICATIONHusqvarna - 51Engine OilChanging the Engine OilIMPORTANT INFORMATIONUsed engine oil is a health hazard and must not be disposed of on the g

LUBRICATION52 - HusqvarnaChecking Oil Level8011-471Oil dipstick8009-159Level markingThe importance of checking and maintaining the proper oil level in

LUBRICATIONHusqvarna - 538011-046Viscosity grades tableOil RecommendationsUsing the proper type and weight of oil in the crankcase is extremely import

LUBRICATION54 - HusqvarnaThrottle and Choke Cables, Lever BearingsLubricate the cable ends by the carburetor with the oil can. Move the controls to th

LUBRICATIONHusqvarna - 55Steering Control ShaftsTip the driver’s seat.Lubricate with a grease gun, one zerk for each steering control shaft, until the

56 - HusqvarnaTROUBLESHOOTING GUIDEProblem CauseThe engine will not start. • The blade switch is engaged.• The steering controls are not locked in t

Husqvarna - 57TROUBLESHOOTING GUIDEProblem CauseThe engine seems weak. • Clogged air lter.• Fouled spark plugs.• Carburetor incorrectly adjusted.T

58 - HusqvarnaSTORAGEWinter StorageAt the end of the mowing season, the machine should be readied for storage (or if it will not be in use for longer

Husqvarna - 59WIRING DIAGRAMBSA1A2LMG20 AMP7.5 AMPELECTRICCLUTCHACCESSORYOUTLETHOURMETERSOLENOIDPTOSWITCHBSA1A2LMGBSA1A2LMGBSA1A2LMGBSA1A2LMGENGINEGRO

6 - HusqvarnaINTRODUCTIONGood ServiceHusqvarna’s products are sold all over the world and only in specialized retail stores with complete service. Thi

60 - HusqvarnaTECHNICAL DATALZC5225 / 965879601 LZC5227 / 965879701EngineManufacturer Kawasaki KohlerType FH721V CV740SPower 25 hp* / 18.4 kW 27hp* /

Husqvarna - 61TECHNICAL DATALZC5225 / 965879601 LZC5227 / 965879701FrameCutting Width 52" / 132 cm 52" / 132 cmCutting Height 1½ - 6" /

62 - HusqvarnaTECHNICAL DATALZC6130 / 965879801 LZ30 / 968999776EngineManufacturer Kohler KohlerType CV747S CV747SPower 30hp* / 22.4kW 30hp* / 22.4kW

Husqvarna - 63TECHNICAL DATALZC6130 / 965879801 LZ30 / 968999776FrameCutting Width 61" / 155 cmCutting Height 1½ - 6" / 3.8 - 15.2 cmUncut C

64 - HusqvarnaTECHNICAL DATAAccessoriesCollection systemEngine crankshaft bolt 50 ft/lb (67 Nm)Deck pulley bolts 150 ft/lb (203 Nm)Lug nuts 75 f

Husqvarna - 65CONFORMITY CERTIFICATESUSA requirementsLabels are placed on the engine and/or in the engine compartment stating that the machine will fu

66 - HusqvarnaWARRANTYAll Husqvarna products can be registered online at www.usa.husqvarna.com quickly and easily regardless of their model year. Clic

Husqvarna - 67SERVICE JOURNALActionDate, mtr reading, stamp, signDelivery Service1. Charge the battery.2. Adjust the tire pressure of all wheels to

68 - HusqvarnaSERVICE JOURNALActionDate, mtr reading, stamp, signAfter the First 5-8 Hours 1. Change engine oil.

Husqvarna - 69SERVICE JOURNALActionDate, mtr reading, stamp, sign25-Hour Service1. Check the fuel pump’s air lter.2. Sharpen/Replace mower blades i

SYMBOLS AND DECALSHusqvarna - 7These symbols are found on the machine and in the operator’s manual.Study them carefully so that you know what they mea

70 - HusqvarnaSERVICE JOURNALActionDate, mtr reading, stamp, sign50-Hour Service1. Perform the 25-hour service.2. Clean/replace the air cleaner’s l

Husqvarna - 71SERVICE JOURNALActionDate, mtr reading, stamp, sign100-Hour Service1. Perform the 25-hour service.2. Perform the 50-hour service.3. C

72 - HusqvarnaSERVICE JOURNALActionDate, mtr reading, stamp, sign300-Hour Service1. Inspect the machine. Come to agreement with the customer as to

Husqvarna - 73SERVICE JOURNALActionDate, mtr reading, stamp, signAt Least Once Each Year1. Clean the engine’s cooling air intake (25 hours).2. Repla

74 - HusqvarnaSERVICE JOURNALActionDate, mtr reading, stamp, sign

P/N 115 138927 R01 06/01/09

SYMBOLS AND DECALS8 - Husqvarna Read Shut off engine and Keep a safe Use on slopes No passengers Operator’s remove key before distance from n

SAFETYHusqvarna - 9Safety InstructionsThese instructions are for your safety. Read them carefully.IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTA